Cisco Cisco Aironet 350 Access Points Notas de publicación
7
Release Notes for Cisco Aironet 340 and 350 Series Access Points and 350 Series Bridges Running Firmware Version 12.00T
OL-3346-01
Installation Notes
Warning
Do not locate the antenna near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, as they may cause serious injury or death.
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, as they may cause serious injury or death.
Power Considerations
Caution
The operational voltage range for 350 series access points and bridges is 24 to 60 VDC, and the nominal
voltage is 48 VDC. Voltage higher than 60 VDC can damage the equipment.
voltage is 48 VDC. Voltage higher than 60 VDC can damage the equipment.
Caution
Cisco Aironet power injectors are designed for use with 350 series access points and 350 series bridges
only. Do not use the power injector with any other Ethernet-ready device. Using the power injector with
other Ethernet-ready devices can damage the equipment.
only. Do not use the power injector with any other Ethernet-ready device. Using the power injector with
other Ethernet-ready devices can damage the equipment.
System Requirements
You must have a 340 or 350 series access point or a 350 series bridge to install firmware version 12.00T.
Version Supported
Your access point must be running firmware version 10.x or later to install firmware version 12.00T.
Your bridge must be running version 11.07 or later to install firmware version 12.00T.
Your bridge must be running version 11.07 or later to install firmware version 12.00T.
Upgrading to a New Firmware Release
Determining the Firmware Version
The firmware version number is in the upper-left corner of most management screens in the web-browser
interface and at the top of the home (Summary Status) page in the command-line interface.
interface and at the top of the home (Summary Status) page in the command-line interface.
Upgrade Procedure
For instructions on installing access point and bridge firmware:
1.
Follow this link to the Cisco Aironet documentation home page:
2.
Follow this path to the product, document, and chapter:
Aironet 350 Series Wireless LAN Products > Cisco Aironet 350 Series Access Points > Cisco
Aironet Access Point Software Configuration Guide > Managing Firmware Configurations >
Updating Firmware
Aironet 350 Series Wireless LAN Products > Cisco Aironet 350 Series Access Points > Cisco
Aironet Access Point Software Configuration Guide > Managing Firmware Configurations >
Updating Firmware
3.
Follow this link to the Software Center on Cisco.com and download firmware version 12.00T: