Cisco Cisco Aironet 350 Workgroup Bridges Guía De Instalación
2
Connect and Power Up the Bridge
Connecting the Ethernet
Cable
Cable
Caution
Make sure the unit is
disconnected from the power
source. Do not connect the Ethernet
cable when the bridge is powered
up.
1
Plug the RJ-45 Ethernet connector into
the Ethernet port on the back of the
bridge.
2
Connect the other end of the cable to a
hub on the wired LAN, as shown in the
figure below, or to the Ethernet
connection on the computer that you
will use to configure the unit.
Note
You must use a crossover cable to
connect the bridge directly to the Ethernet
port on a computer. See the Cisco Aironet
Workgroup Bridge Hardware Installation
Guide for a pinout diagram of a crossover
cable.
ETHERNET
SPEED
1
5
2
6
3
7
4
8
LED
100BaseTX
SOLID
10BaseT
BLINK
1X 2X
3X 4X
5X
6X
7X
MDI
MDI-X
8X
ETHERNET
5VDC
42272
Connecting the Power
Adapter
Adapter
Follow these steps to connect the power
adapter to the bridge:
1
Plug the power adapter into a suitable
power receptacle.
2
Plug the power connector into the back
of the bridge.
Note
The bridge does not have an on/off
switch, so power is applied to the unit when
you plug it in.
The bridge begins the power-on self-test
(POST) when you apply power. The
indicator lights show the unit’s progress
during startup. The indicators
simultaneously flash red, then amber, and
then green. Startup takes approximately 30
seconds.
ETHERNET
5VDC
39281