Cisco Cisco Aironet 350 Access Points Notas de publicación

This section lists important information about access points and bridges running firmware version 
11.23T.

With firmware version 11.23T, you can select no for the Classify Workgroup Bridges as Network 
Infrastructure setting on the AP/Root Radio Advanced page to allow up to 50 workgroup bridges to 
associate to the access point or bridge. After selecting no for this setting, you must reboot workgroup 
bridges associated to the access point or bridge.

The Cisco Discovery Protocol (CDP) feature is enabled by default, and CDP is enabled for each of the 
access point’s or bridge’s individual interfaces by default. However, if you disable CDP for one of the 
individual interfaces, the access point or bridge re-enables CDP for that interface when it reboots. If you 
disable CDP completely, the access point or bridge does not re-enable CDP on reboot.

This section lists open and resolved software issues in firmware version 11.23T.

If you are a registered Cisco user, you can use the Cisco TAC Software Bug Toolkit, which consists of 
three tools (Bug Navigator, Bug Watcher, and Search by Bug ID Number) that help you identify existing 
bugs (or caveats) in Cisco software products. 

http://www.cisco.com/support/bugtools/

.

The following caveats have not been resolved for firmware version 11.23T:

CSCdw89705—When a non-root bridge roams from one root bridge to another, messages might 
appear in the logs of the root bridges stating that Ethernet devices connected to the non-root bridge 
and wireless client devices associated to the non-root bridge have roamed. You can ignore these 
messages.

CSCdy13290—Nested repeaters do not work with static WEP. The problem occurs when nested access 
points or bridge repeaters running 11.21 firmware, as in the following topology: 

Root Repeater

Repeater

(A) (B) 

(C) 

Setting a 40- or 128-bit Static WEP key, will cause repeater (C) to associate to repeater (B), but no data