Cisco Cisco Aironet 350 Wireless Bridge Guía De Información
Cisco Aironet Wireless Bridges FAQ
Document ID: 16041
Contents
Introduction
What is the Cisco Aironet Wireless Bridge?
What are the different platforms of wireless bridges that Cisco offers?
Where can I download the latest firmware, drivers, and software?
How do I connect to my Cisco Aironet Wireless Bridge using the console port?
Can any of the Cisco wireless products perform a wireless bridge at full duplex?
Why do two bridges not communicate automatically, right out of the box?
How do I set the IP address on a wireless bridge?
How do I upgrade the firmware on a bridge?
Can wireless clients associate to the bridge?
How do I save the configuration of the bridge?
Can I disable Aironet extensions on the Cisco Aironet Wireless Bridge?
What devices can associate with a bridge?
At what frequency does a bridge communicate?
What are the different encryption options available with Cisco Aironet Wireless Bridges?
What are the different authentication mechanisms supported with Cisco Aironet Wireless Bridges?
What is a Wired Equivalent Privacy (WEP) key?
How can I recover forgotten passwords on a bridge?
What is the typical range for a wireless bridge?
How fast is the Ethernet port of the bridge?
What are the possible sources of interference for the radio frequency link of the bridge?
How do I set the bridge back to the factory default settings?
What are the different modes supported on wireless bridges?
Do antennas need line of sight to function?
Can the 340 and 350 Series Wireless Bridges be converted to Cisco IOS®?
I just purchased two Cisco 1310 Bridges, which work together. However, the Cisco 342 Bridges that also are
in this wireless network do not work with the Cisco 1300 Bridges. Are these bridges compatible?
Can I configure multiple VLANs on a Cisco 340 Series Wireless Bridge?
When should I set an SSID for infrastructure mode, and how do I set this parameter in a wireless bridge,
access point (AP) or a WGB?
Can a wireless bridge support Netflow, just like Cisco routers?
Can a Cisco 1410 Wireless Bridge support Wi−Fi Protected Access2 (WPA2) or Advanced Encryption
Standard (AES)?
What is the maximum range covered by a 1310 Wireless Bridge when acting in bridge mode as well as in
access point (AP) mode?
Is it possible to combine the wall mount kit with an internal antenna on the 1300 Bridge?
Is it possible to adjust a 1310 Wireless Bridge with an internal antenna that is installed on a wall mount kit, or
is it fixed?
Related Information
What are the different platforms of wireless bridges that Cisco offers?
Where can I download the latest firmware, drivers, and software?
How do I connect to my Cisco Aironet Wireless Bridge using the console port?
Can any of the Cisco wireless products perform a wireless bridge at full duplex?
Why do two bridges not communicate automatically, right out of the box?
How do I set the IP address on a wireless bridge?
How do I upgrade the firmware on a bridge?
Can wireless clients associate to the bridge?
How do I save the configuration of the bridge?
Can I disable Aironet extensions on the Cisco Aironet Wireless Bridge?
What devices can associate with a bridge?
At what frequency does a bridge communicate?
What are the different encryption options available with Cisco Aironet Wireless Bridges?
What are the different authentication mechanisms supported with Cisco Aironet Wireless Bridges?
What is a Wired Equivalent Privacy (WEP) key?
How can I recover forgotten passwords on a bridge?
What is the typical range for a wireless bridge?
How fast is the Ethernet port of the bridge?
What are the possible sources of interference for the radio frequency link of the bridge?
How do I set the bridge back to the factory default settings?
What are the different modes supported on wireless bridges?
Do antennas need line of sight to function?
Can the 340 and 350 Series Wireless Bridges be converted to Cisco IOS®?
I just purchased two Cisco 1310 Bridges, which work together. However, the Cisco 342 Bridges that also are
in this wireless network do not work with the Cisco 1300 Bridges. Are these bridges compatible?
Can I configure multiple VLANs on a Cisco 340 Series Wireless Bridge?
When should I set an SSID for infrastructure mode, and how do I set this parameter in a wireless bridge,
access point (AP) or a WGB?
Can a wireless bridge support Netflow, just like Cisco routers?
Can a Cisco 1410 Wireless Bridge support Wi−Fi Protected Access2 (WPA2) or Advanced Encryption
Standard (AES)?
What is the maximum range covered by a 1310 Wireless Bridge when acting in bridge mode as well as in
access point (AP) mode?
Is it possible to combine the wall mount kit with an internal antenna on the 1300 Bridge?
Is it possible to adjust a 1310 Wireless Bridge with an internal antenna that is installed on a wall mount kit, or
is it fixed?
Related Information
Introduction
This document provides information on the most frequently asked questions about Cisco Aironet Wireless
Bridges.
Bridges.