Cisco Cisco Aironet 1600i Access Point Manual Técnica
and Data Rates match between them.
Make sure that Radio Frequency (RF) environment between AP and WGB is free from interference.
Refer to the RF Impairments section of Troubleshooting Problems Affecting Radio Frequency
Communication for more information.
Refer to the RF Impairments section of Troubleshooting Problems Affecting Radio Frequency
Communication for more information.
•
The debug dot11dot11 0 trace print uplink debug command is useful to use on the WGB. This command
takes you through the join process of a WGB, from scanning (if there are multiple parents), selection process
for the parent, association and dot1x/PSK authentication (if configured) phases. Here is some sample ouput:
takes you through the join process of a WGB, from scanning (if there are multiple parents), selection process
for the parent, association and dot1x/PSK authentication (if configured) phases. Here is some sample ouput:
*Aug 3 09:33:10.607: 16ED71A7−0 Uplink: Stop
*Aug 3 09:33:11.611: 16FCBED3−0 Interface up
*Aug 3 09:33:11.627: 16FCDDCE−0 Uplink: Wait for driver to stop
*Aug 3 09:33:11.627: 16FCDE3D−0 Uplink: Enabling active scan
*Aug 3 09:33:11.627: 16FCDE42−0 Uplink: Not busy, scan all channels
*Aug 3 09:33:11.627: 16FCDE46−0 Uplink: Scanning
*Aug 3 09:33:11.639: 16FD2D1B−0 Uplink: Rcvd response from ccd5.39e3.b260 channel 7 2615
*Aug 3 09:33:11.919: 17017B61−0 Uplink: no rsnie or ssnie chk
*Aug 3 09:33:11.919: 17017B6B−0 Uplink: ssid wgb auth open
*Aug 3 09:33:11.919: 17017B6F−0 Uplink: try ccd5.39e3.b260, enc 0 key 0, priv 0, eap 0
*Aug 3 09:33:11.919: 17017B76−0 Uplink: Authenticating
*Aug 3 09:33:11.923: 1701835E−0 Uplink: Associating
*Aug 3 09:33:11.939: %DOT11−4−UPLINK_ESTABLISHED: Interface Dot11Radio0, Associated To AP root ccd5.39e3.b260 [None]
Updated: May 14, 2014
Document ID: 68472