Cisco Cisco Identity Services Engine Software Manual Técnica

Cisco ISE Versions 1.3 and later

• 

The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.

This section describes how to configure the ISE in order to support email and SMS notifications for various
services.

Before it can use any email services, the ISE must have a Simple Message Transfer Protocol (SMTP) relay
server configured. In order to configure the server, navigate to Administration > System > Settings > SMTP
Server

:

This server should have the ability to accept any emails from the ISE without authentication or encryption.

: For the SMTP relay server configuration, Cisco recommends that you add the ISE IP address to the

exceptions list (no or anonymous authentication) and require authentication from all other hosts.

In order for the SMS services to work with the ISE, you must configure a specific SMS gateway. The ISE
supports Smtp2SMS and Http2SMS gateways. By default, there are nine gateways that are preconfigured for
well known providers (you might might need to tune these). In order to configure these, navigate to
Administration > System > Settings > SMS gateway

: