Cisco Cisco AP541N Wireless Access Point Guía De Instalación

 

To use the 

 button to reboot or reset the access point, do the 

following:

• To reboot the access point, press the 

 button for less than 10 

seconds.

• To restore the access point to the factory default settings:

1. Disconnect the access point from the network or disable all DHCP 

servers on your network.

2. With the power on, press-and-hold the 

 button for more than 

10 seconds.

The access point can be placed on a wall, a flat surface, or a ceiling. A 
ceiling mount kit is available for this device (AP540N-CMK). Do not deploy 
the device in a location where any of the following conditions exist:

High Ambient Temperature—The ambient temperature must not 
exceed 104 degrees Fahrenheit (40C).

Reduced Air Flow—The air flow must be adequate to prevent 
overheating.

Mechanical Overloading—The device should be level, stable, and 
secure to avoid it sliding or shifting out of position.

Circuit Overloading—Adding the device to the power outlet or a PoE 
port must not overload that circuit or PoE device.

We recommend using Cat5e or better cable. Also, do not 
exceed the maximum cabling distance of 328 feet (100 meters).