Cisco Cisco AP541N Wireless Access Point Notas de publicación
Cisco Small Business AP541N Access Point Release Notes for Versions 1.7.2 through 2.0.4
9
Release Notes
CSCtd63503—Wireless IP Phones are Frequently De-registering
The IP phones are able to successfully register with the call manager and make
successful calls. However, the phones de-register after 5 minutes, sometimes in
the middle of a call. The wireless association is maintained. It is possible that the
keepalives (heart beat messages) sent by the phone are not reaching the CME and
the CME de-registers the phones.
successful calls. However, the phones de-register after 5 minutes, sometimes in
the middle of a call. The wireless association is maintained. It is possible that the
keepalives (heart beat messages) sent by the phone are not reaching the CME and
the CME de-registers the phones.
CSCtd63487—Some Pages Render Very Slowly
Some configuration GUI pages render very slowly in the AP541N-1.2(1) image
when the Advanced tab is selected.
when the Advanced tab is selected.
CSCtd62176—Voice Packets are Dropped on RX on the 7921 Clients
Voice packets are dropped on RX on 7921 clients. Call manager uses G.711
codec by default. Tx and RX on both sides should be 50 pps (packets per second).
The TX on the 7960 is 50 pps (equal to Rx on 7921) but the Rx on the 7960 is only
about 40 - 43 pps, about 14% packet drops on the RTP stream from the 7921 to
the 7960.
codec by default. Tx and RX on both sides should be 50 pps (packets per second).
The TX on the 7960 is 50 pps (equal to Rx on 7921) but the Rx on the 7960 is only
about 40 - 43 pps, about 14% packet drops on the RTP stream from the 7921 to
the 7960.
CSCtd62146—Primary Image Corrupted After 10 Days
The primary image is corrupted after 10 days of use. After multiple reboots of a
1.4(0) image it, suddenly was reported as being corrupted and the device booted
of the secondary image.
1.4(0) image it, suddenly was reported as being corrupted and the device booted
of the secondary image.
CSCtd62123—System Time Cannot be Set by using the GUI
The system time parameter cannot be set manually by using the GUI.
CSCtd62096—Remove IPV6 References, as it is not Supported
There are references to IPV6, which is not supported.
CSCtd62087—WPA-PSK-AES Fails If There are Two Open SSID With the Same
Name at Different Security Levels
Name at Different Security Levels
The Cisco device allows two SSIDs to have same name, if they have different
security levels. However, most client devices cannot tell the difference and see
them as one BSSID. If two SSIDs have the same name, one with WPA-PSK-AES
and one without, the network will fail to pass traffic.
security levels. However, most client devices cannot tell the difference and see
them as one BSSID. If two SSIDs have the same name, one with WPA-PSK-AES
and one without, the network will fail to pass traffic.
CSCtd62084—Station Isolation Settings are Not Propagating When Clustering is
Enabled
Enabled
Station isolation settings for VAPs are not propagating when clustering is enabled.