Cisco Cisco WAP4410N Wireless-N Access Point - PoE Advanced Security Manual De Mantenimiento

AP Mode

WAP4410N Wireless-N Access Point with Power Over Internet Administration Guide

43

The AP Mode page displays the AP mode settings for the access point. To 
configure the AP mode of the access point, follow these steps:

Click AP Mode > AP Mode.

Configure the AP Mode settings.

•

Access point—Select to let the device operate as a normal access point.

-

Allow Wireless Signal to be repeated by a repeater—If selected, the 
device will act as a repeater for another access point. Provide the MAC 
addresses of the other access points in the fields.

•

Wireless WDS Repeater—Select to let the access point operate as a 
wireless repeater to extend the radio range of the associated remote 
access point to overcome any obstacle that blocks radio communication. 

-

Remote Access Point’s MAC Address—Enter the MAC address of the 
remote access point directly, or click the Site Survey button to select 
from a list of available access points.

•

Wireless WDS Bridge—Select to let the access point operate as a 
wireless bridge to perform transparent bridging with other associated 
wireless bridges, and not allow any wireless client or station to access 
them.

-

Remote Wireless Bridge’s MAC Address—Enter the MAC addresses 
of the other access points in the fields.

•

Wireless Client/Repeater—Select to let the wireless access point operate 
as a client or repeater access point, sending all traffic received to another 
access point.

-

Allow wireless stations to associate—Enable or disable this setting.

-

Remote access point—Enter the MAC address and SSID of the desired 
access point or click the Site Survey button to choose the access point 
from the available networks.

•

Wireless Monitor—Allows the access point to detect unauthorized (rogue) 
access points on your network.

-

No Security—Check to identify any access point operating with 
security disabled as a rogue access point.