Cisco Cisco Packet Data Gateway (PDG) Guía De Administador
Troubleshooting
▀ Detecting Faulty Hardware
▄ Cisco ASR 5000 System Administration Guide
206
The possible states for all of the SPIO LEDs are described in the sections that follow.
SPIO Run/Fail LED States
The SPIO Run/Fail LED indicates the overall status of the card. This LED should be green for normal operation.
The possible states for this LED are described in the following table. If the LED is not green, use the troubleshooting
information in the table to diagnose the problem.
information in the table to diagnose the problem.
Table 23.
SPIO Run/Fail LED States
Color
Description
Troubleshooting
Green
Card powered with no
errors detected.
errors detected.
None needed.
Red
Card powered with
error(s) detected.
error(s) detected.
Errors were detected during the Power On Self Tests (POSTs). It is likely that the errors
were logged to the command line interface during the boot process.
were logged to the command line interface during the boot process.
Refer to Monitoring the System for information on determining the status of system
hardware components.
hardware components.
None
Card is not receiving
power.
power.
for troubleshooting information.
Verify that the power source is supplying ample voltage and current to the chassis.
Verify that the card is properly installed per the instructions in the ASR 5000 Installation
Guide.
Guide.
If all of the above suggestions have been verified, it is possible that the SPIO is not
functional. Please contact your service representative.
functional. Please contact your service representative.
SPIO Active LED States
The Active LED on the SPIO indicates that the software is loaded on the card and that the card is ready for operation.
For the SPIO installed in chassis slot 24, this LED should be green for normal operation. For the SPIO installed in slot
25, this LED should be off for normal operation.
For the SPIO installed in chassis slot 24, this LED should be green for normal operation. For the SPIO installed in slot
25, this LED should be off for normal operation.
The possible states for this LED are described in the following table. If the LED is not green, use the troubleshooting
information in the table to diagnose the problem.
information in the table to diagnose the problem.