Cisco Cisco Packet Data Gateway (PDG) Guía De Administador
Verifying and Saving Your Configuration
▀ Verifying the Configuration
▄ Cisco ASR 5000 System Administration Guide
92
Verifying the Configuration
You can use a number of commands to verify the configuration of your feature, service, or system. Many are
hierarchical in their implementation and some are specific to portions of or specific lines in the configuration file.
hierarchical in their implementation and some are specific to portions of or specific lines in the configuration file.
Feature Configuration
In many configurations, you have to set and verify specific features. An example includes IP address pool configuration.
Using this example, enter the following commands to verify proper feature configuration:
Using this example, enter the following commands to verify proper feature configuration:
Enter the show ip pool command to display the IP address pool configuration. The output from this command should
look similar to the sample shown below. In this example, all IP pools were configured in the isp1 context.
look similar to the sample shown below. In this example, all IP pools were configured in the isp1 context.
context : isp1:
+-----Type: (P) - Public (R) - Private
| (S) - Static (E) - Resource
|
|+----State: (G) - Good (D) - Pending Delete (R)-Resizing
||
||++--Priority: 0..10 (Highest (0) .. Lowest (10))
||||
||||+-Busyout: (B) - Busyout configured
||||||
vvvvvv Pool Name Start Address Mask/End Address Used Avail
----- ----------------------- --------------- --------------- ----------------
PG00 ipsec 12.12.12.0 255.255.255.0 0 254
PG00 pool1 10.10.0.0 255.255.0.0 0 65534
SG00 vpnpool 192.168.1.250 192.168.1.254 0 5
Total Pool Count: 5
+-----Type: (P) - Public (R) - Private
| (S) - Static (E) - Resource
|
|+----State: (G) - Good (D) - Pending Delete (R)-Resizing
||
||++--Priority: 0..10 (Highest (0) .. Lowest (10))
||||
||||+-Busyout: (B) - Busyout configured
||||||
vvvvvv Pool Name Start Address Mask/End Address Used Avail
----- ----------------------- --------------- --------------- ----------------
PG00 ipsec 12.12.12.0 255.255.255.0 0 254
PG00 pool1 10.10.0.0 255.255.0.0 0 65534
SG00 vpnpool 192.168.1.250 192.168.1.254 0 5
Total Pool Count: 5
Important:
To configure features on the system, use the show commands specifically for these features. Refer to
the Exec Mode show Commands chapter in the Command Line Interface Reference for more information.
Service Configuration
Verify that your service was created and configured properly by entering the following command:
show service_type service_name
The output is a concise listing of the service parameter settings similar to the sample displayed below. In this example, a
P-GW service called pgw is configured.
P-GW service called pgw is configured.