Cisco Cisco Packet Data Interworking Function (PDIF)
AAA Interface Configuration
Configuring Diameter AAA Functionality ▀
AAA Interface Administration and Reference, StarOS Release 19 ▄
35
Verifying Your Configuration
To verify your configurations:
In the Exec mode, enter the following command:
show diameter dynamic-dictionary all [ contents ]
The output displays a concise list of settings that you have configured.
Configuring Rate Limiting Function Template
This section describes how to configure Rate LimitingFunction (RLF) Template at the global level.
Important:
Rate Limiting Function (RLF) is a license-controlled feature. A valid feature license must be
installed prior to configuring this feature. Contact your Cisco account representative for more information.
The RLF template defines the rate limiting configurations for example, a threshold for rate-limiting the outgoing
messages. The template can be used by any product/interface that needs to throttle and rate control the messages sent to
the external network interfaces.
messages. The template can be used by any product/interface that needs to throttle and rate control the messages sent to
the external network interfaces.
To configure RLF template at the global level use the following configuration:
configure
rlf-template <template_name>
delay-tolerance tolerance_value [ -noconfirm ]
msg-rate tps_value burst-size size [ -noconfirm ]
threshold { lower lowerThreshold_value | upper upperThreshold_value } [ -
noconfirm ]
noconfirm ]
end
For information on the commands, refer to the Rate Limiting Function Template Configuration Mode Commands
chapter of the Command Line Interface Reference.
chapter of the Command Line Interface Reference.
Verifying Your Configuration
To verify your configurations:
In the Exec mode, enter the following command:
show rlf-template all
The output displays a concise list of settings that you have configured.