Cisco Cisco Packet Data Interworking Function (PDIF)
Encoding Destination-Host AVP in Redirected Requests
Configuring Destination-Host AVP in Redirected Request ▀
AAA Interface Administration and Reference, StarOS Release 19 ▄
73
Configuring Destination-Host AVP in Redirected Request
This section provides information on the commands used to include the Destination-Host AVP in the redirected request
messages.
messages.
Encoding Destination-Host AVP in Redirected Requests
Use the following configuration commands to include the Destination-Host AVP in the redirected request messages on
ePDG, P-GW and SaMOG sent over the respective authentication interfaces (SWm, S6b and STa).
ePDG, P-GW and SaMOG sent over the respective authentication interfaces (SWm, S6b and STa).
configure
context context_name
diameter endpoint endpoint_name
destination-host-avp { always | initial-request [ redirected-request ] | retried-
request [ redirected-request ] | session-binding [ redirected-request ] }
request [ redirected-request ] | session-binding [ redirected-request ] }
default destination-host-avp
end
Notes:
redirected-request
: Encodes the Destination-Host AVP in any redirected request message.
always
: Encodes the Destination-Host AVP in all types of request messages.
initial-request
: Encodes the Destination-Host AVP in initial request but not in retried request.
retried-request
: Encodes the Destination-Host AVP in retried request but not in initial request.
session-binding
: Encodes the Destination-Host AVP after the Diameter session is bound with a host.