Cisco Cisco Packet Data Gateway (PDG)
Management Settings
SNMP Support ▀
ASR 5500 System Administration Guide, StarOS Release 18 ▄
89
CISCO-ENTITY-DISPLAY-MIB : Disabled
CISCO-PROCESS-MIB : Disabled
CISCO-ENTITY-FRU-CONTROL-MIB : Disabled
CISCO-PROCESS-MIB : Disabled
CISCO-ENTITY-FRU-CONTROL-MIB : Disabled
Step 2
Verify that the SNMP community(ies) were configured properly by entering the following command:
show snmp communities
The output of this command lists the configured SNMP communities and their corresponding access levels.
Step 3
Verify that the SNMP transports are configured properly by entering the following command:
show snmp transports
The following displays a sample output:
Target Name: rms1
IP Address: 192.168.1.200
Port: 162
Default: Default
Security Name: public
Version: 1
Security:
View:
Notif Type: traps
IP Address: 192.168.1.200
Port: 162
Default: Default
Security Name: public
Version: 1
Security:
View:
Notif Type: traps
Controlling SNMP Trap Generation
The system uses SNMP traps (notifications) to indicate that certain events have occurred. By default, the system enables
the generation of all traps. However, you can disable individual traps to allow only traps of a certain type or alarm level
to be generated. This section provides instructions for disabling/enabling SNMP traps.
the generation of all traps. However, you can disable individual traps to allow only traps of a certain type or alarm level
to be generated. This section provides instructions for disabling/enabling SNMP traps.
Important:
Commands used in the configuration samples in this section provide base functionality. The most
common commands and keyword options are presented. In many cases, other optional commands and keyword options
are available. Refer to the Command Line Interface Reference for complete information regarding all commands.
are available. Refer to the Command Line Interface Reference for complete information regarding all commands.
To configure SNMP trap generation:
Step 1
Set parameters by applying the following example configuration:
configure
snmp trap suppress
snmp trap suppress trap_name1 trap_name2 ... trap_nameN
Important:
If at a later time you wish to re-enable a trap that was previously suppressed, use the snmp trap
enable command.
snmp trap enable trap_name1 trap_name2 ... trap_nameN target target-name
Step 2
Save the configuration as described in Verifying and Saving Your Configuration.