Cisco Cisco Packet Data Interworking Function (PDIF)
System Operation and Configuration
▀ Terminology
▄ ASR 5500 System Administration Guide, StarOS Release 17
20
Terminology
This section defines important terms used throughout this guide.
Contexts
A context is a logical grouping or mapping of configuration parameters that pertain to various physical ports, logical IP
interfaces, and services. A context can be thought of as a virtual private network (VPN).
interfaces, and services. A context can be thought of as a virtual private network (VPN).
The system supports the configuration of multiple contexts. Each context is configured and operates independently of
the others. Once a context has been created, administrative users can configure services, logical IP interfaces, and
subscribers for that context and then bind the logical interfaces to physical ports.
the others. Once a context has been created, administrative users can configure services, logical IP interfaces, and
subscribers for that context and then bind the logical interfaces to physical ports.
You can also assign a domain alias to a context; if a subscriber’s domain name matches one of the configured alias
names for a context, that context is used.
names for a context, that context is used.
Ports
Ports are the physical connectors on line cards that support remote access and subscriber traffic. Port configuration
includes traffic profiles, data encapsulation methods, media type, and other information for physical connectivity
between the system and the rest of the network.
includes traffic profiles, data encapsulation methods, media type, and other information for physical connectivity
between the system and the rest of the network.
Ports are identified by the chassis slot number for the Management Input/Output (MIO) or Management I/O Universal
Card (UMIO) card, followed by the physical connector number. For example, Port 5/10 identifies connector number 10
on the MIO/UMIO card in slot 5.
Card (UMIO) card, followed by the physical connector number. For example, Port 5/10 identifies connector number 10
on the MIO/UMIO card in slot 5.
Associate ports with contexts through bindings. For additional information on bindings, refer to the Bindings section
below. You can configure each physical port to support multiple logical IP interfaces, each with up to 17 IP addresses
(one primary and up to 16 secondaries).
below. You can configure each physical port to support multiple logical IP interfaces, each with up to 17 IP addresses
(one primary and up to 16 secondaries).
For complete information on line cards and port assignments, refer to the ASR 5500 Installation Guide.
Important:
UMIO cards and UDPCs are direct replacements for MIO cards and DPCs. However, a special
Universal PID license must be purchased and installed on the chassis for each installed UMIO and UDPC. Contact your
Cisco account representative for additional licensing information.
Cisco account representative for additional licensing information.
Important:
Throughout this guide, any reference to an MIO card or DPC is assumed to also refer to the UMIO
and UDPC respectively.
Logical Interface
You must associate a port with a virtual circuit or tunnel called a logical interface before the port can allow the flow of
user data. A logical interface within the system is the assignment of a virtual router instance that provides higher-layer
protocol transport, such as Layer 3 IP addressing. Interfaces are configured as part of the VPN context and are
independent from the physical port that will be used to bridge the virtual interfaces to the network.
user data. A logical interface within the system is the assignment of a virtual router instance that provides higher-layer
protocol transport, such as Layer 3 IP addressing. Interfaces are configured as part of the VPN context and are
independent from the physical port that will be used to bridge the virtual interfaces to the network.
There are several types of logical interfaces to configure to support Simple and Mobile IP data applications.