Cisco Cisco Packet Data Interworking Function (PDIF)
Software Management Operations
▀ Maintaining the Local File System
▄ ASR 5000 System Administration Guide, StarOS Release 18
132
Maintaining the Local File System
Use CLI commands to manage and maintain the devices that make up the local file system. Execute all the commands
described in this section in the Exec Mode. Unless otherwise specified, you must have security administrator or
administrator privileges to execute these commands.
described in this section in the Exec Mode. Unless otherwise specified, you must have security administrator or
administrator privileges to execute these commands.
Important:
For complete information about the commands listed below, see the Exec Mode Commands chapter
of the Command Line Interface Reference.
File System Management Commands
Use the commands in this section to manage and organize the local file system.
Synchronizing the File System
Commands are supported for mirroring the local file systems from the active SMC to the standby SMC in systems
containing two cards. Use these commands to synchronize any or all of the local devices.
containing two cards. Use these commands to synchronize any or all of the local devices.
Important:
Crash log files are not synchronized when these commands are executed.
The following command synchronizes the file systems between two SMCs:
[local]host_name# filesystem synchronize { / flash | /pcmcia1 | all } [ checkonly ]
[ from | to ] } [ -noconfirm ]
[ from | to ] } [ -noconfirm ]
The following command synchronizes the file systems on two SMC /flash devices.
[local]host_name# filsystem synchronize /flash
Creating Directories
Use the mkdir command to create a new directory on the specific local device. This directory can then be incorporated
as part of the path name for any file located in the local file system.
as part of the path name for any file located in the local file system.
[local]host_name# mkdir { /flash | /pcmcia1 | /hd-raid } /dir_name
Use the following command to create a directory named configs:
[local]host_name# mkdir /flash/configs
Renaming Files and Directories
Use the rename command to change the name of a file from its original name to a different name. Remember to use the
same file extension, if applicable, to ensure that the file type remains unchanged.
same file extension, if applicable, to ensure that the file type remains unchanged.