Cisco Cisco Packet Data Gateway (PDG)
VLANs
▀ Verifying the Port Configuration
▄ ASR 5000 System Administration Guide, StarOS Release 16
292
Verifying the Port Configuration
Run the following command to verify the port configuration:
show port info slot/port
An example of this command’s output when at least one VLAN has been configured for the port is shown below:
Port: 17/1
Port Type : 1000 Ethernet
Role : Service Port
Description : (None Set)
Controlled By Card : 1 (Packet Services Card)
Redundancy Mode : Port Mode
Framing Mode : Unspecified
Redundant With : 33/1
Physical ifIndex : 553713664
Administrative State : Enabled
Configured Duplex : Auto
Configured Speed : Auto
MAC Address : 02-05-47-72-78-00
Boxer Interface TAP : None
Link State : Up
Link Duplex : Unknown
Link Speed : Unknown
Flow Control : Disabled
Link Aggregation Group : None
Untagged:
Logical ifIndex : 285278209
Operational State : Up, Active
Tagged VLAN: VID 10
Logical ifIndex : 285278210
VLAN Type : Subscriber
VLAN Priority : 0
Administrative State : Enabled
Operational State : Up, Active
Number of VLANs : 1
SFP Module : Not Present
Port Type : 1000 Ethernet
Role : Service Port
Description : (None Set)
Controlled By Card : 1 (Packet Services Card)
Redundancy Mode : Port Mode
Framing Mode : Unspecified
Redundant With : 33/1
Physical ifIndex : 553713664
Administrative State : Enabled
Configured Duplex : Auto
Configured Speed : Auto
MAC Address : 02-05-47-72-78-00
Boxer Interface TAP : None
Link State : Up
Link Duplex : Unknown
Link Speed : Unknown
Flow Control : Disabled
Link Aggregation Group : None
Untagged:
Logical ifIndex : 285278209
Operational State : Up, Active
Tagged VLAN: VID 10
Logical ifIndex : 285278210
VLAN Type : Subscriber
VLAN Priority : 0
Administrative State : Enabled
Operational State : Up, Active
Number of VLANs : 1
SFP Module : Not Present
Notes:
Repeat this sequence as needed to verify additional ports.
more information.
Save your configuration as described in the Verifying and Saving Your Configuration chapter.