Cisco Cisco Packet Data Interworking Function (PDIF)
Troubleshooting
Detecting Faulty Hardware ▀
ASR 5000 System Administration Guide, StarOS Release 16 ▄
201
The possible states for all SMC LEDs are described in the sections that follow.
SMC Run/Fail LED States
The SMC Run/Fail LED indicates the overall status of the card. This LED should be green for normal operation.
The possible states for this LED are described in the following table. If the LED is not green, use the troubleshooting
information in the table to diagnose the problem.
information in the table to diagnose the problem.
Table 14.
SMC Run/Fail LED States
Color
Description
Troubleshooting
Green
Card powered with no
errors detected.
errors detected.
None needed.
Blinking
Green
Green
Card is initializing
and/or loading
software.
and/or loading
software.
This is normal operation during boot-up.
Red
Card powered with
error(s) detected.
error(s) detected.
Errors were detected during the Power On Self Tests (POSTs). It is likely that the errors
were logged to the command line interface during boot. Refer to one or more of the
following to help analyze this problem.
were logged to the command line interface during boot. Refer to one or more of the
following to help analyze this problem.
Monitoring the System for
show
commands, the outputs of which will assist in further
determining the problem.
System Logs for information on how to view logs.
The SNMP MIB Reference for information on associated status and alarm conditions.
None
Card is not receiving
power.
power.
for troubleshooting information.
Verify that the power source is supplying ample voltage and current to the chassis.
Verify that the card is properly installed per the instructions in the ASR 5000 Installation
Guide.
Guide.
If all of the above suggestions have been verified, it is possible that the SMC is not
functional. Please contact your service representative.
functional. Please contact your service representative.
SMC Active LED States
The Active LED on the SMC indicates that the software is loaded on the card and it is ready for operation. For the SMC
installed in chassis slot 8, this LED should be green for normal operation. For the SMC installed in slot 9, this LED
should be off for normal operation.
installed in chassis slot 8, this LED should be green for normal operation. For the SMC installed in slot 9, this LED
should be off for normal operation.
The possible states for this LED are described in the following table. If the LED is not green, use the troubleshooting
information in the table to diagnose the problem.
information in the table to diagnose the problem.