Cisco Cisco Packet Data Interworking Function (PDIF)
Getting Started
▀ ASR 5000 Configuration
▄ ASR 5000 System Administration Guide, StarOS Release 16
36
ASR 5000 Configuration
The first time power is applied to the system, the active System Management Card (SMC) (typically the one installed in
chassis slot 8) automatically launches a Quick Setup Wizard on its console port.
chassis slot 8) automatically launches a Quick Setup Wizard on its console port.
The serial console port is located on the SPIO card installed in slot 24. This wizard is guides you through the initial
configuration of the system.
configuration of the system.
You can choose not to use the wizard and perform the initial configuration by issuing commands via the command line
interface (CLI). You can manually launch the wizard by running the setup command in the Exec mode. Refer to the
Command Line Interface Reference for details.
interface (CLI). You can manually launch the wizard by running the setup command in the Exec mode. Refer to the
Command Line Interface Reference for details.
The following sections describe how to configure the system.
Using the ASR 5000 Quick Setup Wizard
The Quick Setup Wizard consists of three parts:
Configuring a context-level security administrator and hostname
Configuring the Ethernet interface for out-of-band (OOB) management
Configuring the system for remote CLI access via Telnet, Secure Shell (SSH), or File Transfer Protocol (FTP)
The following figure and table provides a flow diagram that shows the run logic of the wizard along with additional
information and notes.
information and notes.