Cisco Cisco Packet Data Gateway (PDG)
dns
Configure the primary and secondary IPv4 or IPv6 address of the DNS servers.
Product
SaMOG
Privilege
Administrator
Command Modes
Exec > Global Configuration > APN Profile Configuration
configure > apn-profile profile_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(apn-profile-
profile_name
)#
Syntax Description
dns [ ipv6 ] { primary | secondary } ip_address
[ no ] dns [ ipv6 ] { primary | secondary }
[ no ] dns [ ipv6 ] { primary | secondary }
no
If previously configured, removes the DNS primary or secondary IP address to be used for web authorization.
ipv6
Specify IPv6 DNS server(s) to enable Flow-based Local Breakout GTPv2 sessions.
primary | secondary IP_address
Specify the primary or secondary DNS server address using the primary | secondary keywords.
ip_address must be expressed in IPv4 dotted-decimal or IPv6 colon-separated (when the ipv6 keyword is
configured)notation format.
configured)notation format.
Usage Guidelines
Use this command to configure the IPv4 or IPv6 address of the primary and secondary DNS servers to be
used during session setup. The primary and secondary DNS servers specified in this configuration will be
used only if the AAA server does not specify the same.
used during session setup. The primary and secondary DNS servers specified in this configuration will be
used only if the AAA server does not specify the same.
This command is license dependent. Contact your Cisco account representative for more information on
SaMOG feature license requirements.
SaMOG feature license requirements.
Important
Command Line Interface Reference, Modes A - B, StarOS Release 19
1448
APN Profile Configuration Mode
dns