Cisco Cisco Packet Data Gateway (PDG)

active-charging link-monitor tcp

Enables the TCP link monitoring feature on the Mobile Video Gateway. This command can be configured in
either APN Configuration Mode or Subscriber Configuration Mode.

Product

MVG

Privilege

Security Administrator, Administrator

Command Modes

Exec > Global Configuration > Context Configuration > APN Configuration

configure > context context_name > apn apn_name

Entering the above command sequence results in the following prompt:

[

context_name

]

host_name

(config-apn)#

Syntax Description

[ default | no ] active-charging link-monitor tcp [ log [ rtt [ histogram | time-series ] [ bitrate [ histogram

| time-series ] ] | bitrate [ histogram | time-series ] [ rtt [ histogram | time-series ] ] ] ] [ -noconfirm ]

default

Sets TCP link monitoring to its default value, which is the same as no.

Deletes the TCP link monitoring settings and disables TCP link monitoring if previously configured.

link-monitor tcp

Enables the TCP link monitoring feature on the Mobile Video Gateway. Note that TCP link monitoring is not
enabled by default. Also note that when this command is configured without the log option, TCP link monitoring
is enabled without logging, and the output from TCP link monitoring is only used by the dynamic translating
feature.

This option enables statistical logging for TCP link monitoring.

The rtt option can be used to enable either histogram or time-series logging for RTT.

Similarly, the bitrate option can be used to enable either histogram or time-series logging for bit rate.

When rtt and bitrate options are used without additional options, histogram and time-series logging are
enabled for RTT and/or bit rate respectively.

Command Line Interface Reference, Modes A - B, StarOS Release 19

1533

APN Configuration Mode Commands

active-charging link-monitor tcp