Cisco Cisco Packet Data Gateway (PDG)
dhcp service-name
Configures the name of a specific DHCP service to use when dynamically assigning IP addresses to PDP
contexts using the Dynamic Host Control Protocol.
contexts using the Dynamic Host Control Protocol.
Product
GGSN
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > APN Configuration
configure > context context_name > apn apn_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-apn)#
Syntax Description
[
no
]
dhcp service-name service_name
no
Removes a previously configured DHCP service name.
service_name
Configures the name of the DHCP service instance that is to be used by the current APN for the dynamic
assignment of IP addresses to PDP contexts. The name can be an alphanumeric string of 1 through 63 characters
that is case sensitive.
assignment of IP addresses to PDP contexts. The name can be an alphanumeric string of 1 through 63 characters
that is case sensitive.
Usage Guidelines
Use this command to specify a pre-configured DHCP service instance that is to be used by the APN for IP
address assignment when the Dynamic Host Control Protocol is used.
address assignment when the Dynamic Host Control Protocol is used.
The name of the context in which the desired DHCP service is configured must be specified by the dhcp
context-name command.
context-name command.
Examples
The following command instructs the APN to use a DHCP service called dhcp1:
dhcp service-name dhcp1
dhcp service-name dhcp1
Command Line Interface Reference, Modes A - B, StarOS Release 19
1582
APN Configuration Mode Commands
dhcp service-name