Cisco Cisco Packet Data Interworking Function (PDIF)
flow limit-across-applications
This command allows you to limit the total number of simultaneous flows per Subscriber/APN sent to a
rulebase regardless of the flow type, or limit flows based on the protocol type under the Session Control
feature.
rulebase regardless of the flow type, or limit flows based on the protocol type under the Session Control
feature.
Product
ACS
Privilege
Security Administrator, Administrator
Command Modes
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-rule-base)#
Syntax Description
flow limit-across-applications { limit | non-tcp limit | tcp limit }
no flow limit-across-applications [ non-tcp | tcp ]
no flow limit-across-applications [ non-tcp | tcp ]
no
If previously configured, deletes the flow limit-across-applications configuration from the current rulebase.
flow limit-across-applications limit
Specifies the maximum number of flows across all applications for the rulebase.
limit must be an integer from 1 through 4000000000.
Default: No limits
non-tcp limit
Specifies the maximum limit of non-TCP type flows.
limit must be an integer from 1 through 4000000000.
Default: No limits
tcp limit
Specifies the maximum limit of TCP flows.
limit must be an integer from 1 through 4000000000.
Default: No limits
Command Line Interface Reference, Modes A - B, StarOS Release 19
681
ACS Rulebase Configuration Mode Commands
flow limit-across-applications