Cisco Cisco Packet Data Gateway (PDG)

paging open-hnb

Configures paging optimization parameters for open HNBs connected through Open Access mode in the
HNB-GW service instance. In this release it is used to configure paging optimization for Open Access mode
support only. This command is depricated release 15.0 onwards. Paging optimization can be configured using
other paging commands available in this chapter.

From Release14.0 and onward this command is part of HNB-Global Configuration Mode.

Important

From Release 16 and later, this command has been deprecated.

Important

Product

HNB-GW

Privilege

Security Administrator, Administrator

Command Modes

Exec > Global Configuration > Context Configuration > HNB-GW Service Configuration

configure > context context_name > hnbgw-service service_name

Entering the above command sequence results in the following prompt:

[local]

host_name

(config-hnbgw-service)#

Syntax Description

paging open-hnb [hnb-where-ue-registered fallback ] {always | never | only-if-with-paging-area}
default paging open-hnb

default

Sets the default behavior of paging optimization configuration for an open HNB while using Open Access
mode support.

By default the HNB-GW pages open HNBs only if paging-area IE is received in the paging message.

{always | never | only-if-with-paging-area}

Sets the HNB-GW service instance to page open HNB for a paging message.

always: Sets the system to ALWAYS page the open HNBs irrespective of paging-area IE is received in
paging messages.

never: Sets the system to NEVER page any open HNB.

Command Line Interface Reference, Modes G - H, StarOS Release 19

1431

HNB-GW Service Configuration Mode Commands

paging open-hnb