Cisco Cisco Packet Data Gateway (PDG)
[ no ] port-specific { slot/port | all } [ rx-utilization percent ] [ tx-utilization percent]
Default: Disabled
Sets port-specific thresholds. If you set port-specific thresholds, when any individual port-specific threshold
is reached, congestion control is applied system-wide.
is reached, congestion control is applied system-wide.
slot/port: Specifies the port for which port-specific threshold monitoring is being configured. The slot and
port must refer to an installed card and port.
port must refer to an installed card and port.
all: Set port specific threshold monitoring for all ports on all cards.
rx-utilization percent: Default 80%. The average percent utilization of port resources for the specified port
by received data as measured in 5-minute intervals. percent must an integer from 0 through 100.
by received data as measured in 5-minute intervals. percent must an integer from 0 through 100.
tx-utilization percent: Default 80%. The average percent utilization of port resources for the specified port
by transmitted data as measured in 5-minute intervals. percent must be an integer from 0 through 100.
by transmitted data as measured in 5-minute intervals. percent must be an integer from 0 through 100.
[ no ] port-tx-utilization percent
Default: 80
The average percent utilization of port resources for all ports by transmitted data as measured in 5-minute
intervals.
intervals.
percent can be an integer from 0 through 100.
service-control-cpu-utilization percent
Default: 80
The average percent utilization of CPUs on which a Demux Manager software task instance is running as
measured in 10-second intervals.
measured in 10-second intervals.
percent can be an integer from 0 through 100.
system-cpu-utilization percent
Default: 80
The average percent utilization for all PAC/PSC/PSC2 CPUs available to the system as measured in 10-second
intervals.
intervals.
percent can be an integer from 0 through 100.
This threshold setting can be disabled with no congestion-control threshold system-cpu-utilization command.
In case later you want to enable the same threshold setting congestion-control threshold
system-cpu-utilization command will enable the CPU utilization threshold to preconfigured level.
In case later you want to enable the same threshold setting congestion-control threshold
system-cpu-utilization command will enable the CPU utilization threshold to preconfigured level.
system-memory-utilization percent
Default: 80
The average percent utilization of all CPU memory available to the system as measured in 10-second intervals.
percent can be an integer from 0 through 100.
tolerance percent
Default: 10
The percentage under a configured threshold that dictates the point at which the condition is cleared.
Command Line Interface Reference, Modes G - H, StarOS Release 19
156
Global Configuration Mode Commands (A-K)
congestion-control threshold