Cisco Cisco Packet Data Gateway (PDG)
threshold diameter diameter-retry-rate
Configures Diameter Retry Rate, alarm or alert thresholds based on the percentage of Diameter requests that
were retried during the polling interval.
were retried during the polling interval.
Product
ACS
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]
host_name
(config)#
Syntax Description
threshold diameter diameter-retry-rate high_thresh [ clear low_thresh ]
default threshold diameter diameter-retry-rate
default threshold diameter diameter-retry-rate
default
Configures this command with the default threshold settings.
Default: 0—disabled
high_thresh
Specifies the high threshold. If, within the polling interval, the percentage of Diameter requests retried equals
or exceeds high_thresh an alert or alarm is generated.
or exceeds high_thresh an alert or alarm is generated.
high_thresh is an integer from 0 through 100.
Default: 0
clear low_thresh
Specifies the low threshold. If, within the polling interval, the percentage of Diameter requests retried falls
below low_thresh, a clear alarm is generated.
below low_thresh, a clear alarm is generated.
low_thresh is an integer from 0 through 100.
Default: 0
Command Line Interface Reference, Modes G - H, StarOS Release 19
505
Global Configuration Mode Commands (T-threshold phspc)
threshold diameter diameter-retry-rate