Cisco Cisco Packet Data Gateway (PDG)
threshold subscriber total
Configures alarm or alert thresholds for the total number of active and inactive subscribers in the system.
Product
PDSN
GGSN
HA
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]
host_name
(config)#
Syntax Description
threshold subscriber total high_thresh [ clear low_thresh ]
high_thresh
Default: 0
Specifies the high threshold number of subscriber sessions (active and dormant) facilitated by the system that
must be met or exceeded within the polling interval to generate an alert or alarm.
must be met or exceeded within the polling interval to generate an alert or alarm.
high_thresh is an integer from 0 through 4000000. A value of 0 disables the threshold.
clear low_thresh
Default: 0
Specifies the low threshold number of subscriber sessions (active and dormant) facilitated by the system that
maintains a previously generated alarm condition. If the number of sessions falls beneath the low threshold
within the polling interval, a clear alarm will be generated.
maintains a previously generated alarm condition. If the number of sessions falls beneath the low threshold
within the polling interval, a clear alarm will be generated.
low_thresh is an integer from 0 and 4000000. A value of 0 disables the threshold.
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm model,
the system assumes it is identical to the high threshold.
the system assumes it is identical to the high threshold.
Important
Command Line Interface Reference, Modes G - H, StarOS Release 19
912
Global Configuration Mode Commands (threshold ppp - url-blacklisting)
threshold subscriber total