Cisco Cisco Packet Data Interworking Function (PDIF)
fabric fsc-auto-recovery
Enables or disables Fabric Storage Card (FSC) fabric recovery via automatic resets on the ASR 5500.
Product
All
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]
host_name
(config)#
Syntax Description
fabric fsc-auto-recovery { disable | enable } [ max-attempts [ number_attempts | unlimited ] ]
{ disable | enable }
Disable turns off the automatic FSC recovery feature.
Enable turns on the automatic FSC recovery feature. When enabled the FSC will initiate auto recovery/reset
upon detecting an excessive number of discarded fabric egress (EGQ) packets.
upon detecting an excessive number of discarded fabric egress (EGQ) packets.
[ max-attempts [ number_attempts | unlimited ]
Specifies how many times StarOS will attempt to reset each FSC as an integer from 1 to 99 or unlimited (will
not stop until FSC is reset). Default is 1.
not stop until FSC is reset). Default is 1.
Usage Guidelines
Use this command to enable or disable automatic FSC auto recovery/reset in the ASR 5500 upon detecting
an excessive number of discarded egress packets. You can optionally specify the maximum number of reset
attempts; the default is 1.
an excessive number of discarded egress packets. You can optionally specify the maximum number of reset
attempts; the default is 1.
To enable this feature, you must first configure the Fabric Egress Drop Threshold via the Global
Configuration mode fabric egress drop-threshold command.
Configuration mode fabric egress drop-threshold command.
Important
Examples
The following command enables FSC automatic recovery with a maximum of 50 attempts.
fabric fsc-auto-recovery enable max-attempts 50
fabric fsc-auto-recovery enable max-attempts 50
Command Line Interface Reference, Modes G - H, StarOS Release 19
219
Global Configuration Mode Commands (A-K)
fabric fsc-auto-recovery