Cisco Cisco Packet Data Interworking Function (PDIF)
threshold asngw-network-entry-denial
Configures alarm or alert thresholds for denials of network entry to an MS within the ASN-GW service.
Product
ASN-GW
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]
host_name
(config)#
Syntax Description
threshold asngw-network-entry-denial high_thresh [ clear low_thresh ]
default threshold asngw-network-entry-denial
default threshold asngw-network-entry-denial
high_thresh
Default: 0
Specifies the high threshold number of denial of network entry to an MS that must be met or exceeded within
the polling interval to generate an alert or alarm.
the polling interval to generate an alert or alarm.
high_thresh is an integer from 0 through 10000000. A value of 0 disables the threshold.
clear low_thresh
Default: 0
Specifies the low threshold number of denial of network entry to an MS that maintains a previously generated
alarm condition. If the number of denials falls beneath the low threshold within the polling interval, a clear
alarm will be generated.
alarm condition. If the number of denials falls beneath the low threshold within the polling interval, a clear
alarm will be generated.
low_thresh is an integer from 0 through 10000000. A value of 0 disables the threshold.
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm model,
the system assumes it is identical to the high threshold.
the system assumes it is identical to the high threshold.
Important
Command Line Interface Reference, Modes G - H, StarOS Release 19
455
Global Configuration Mode Commands (T-threshold phspc)
threshold asngw-network-entry-denial