Cisco Cisco Packet Data Interworking Function (PDIF)
natt
Configures Network Address Translation - Traversal (NAT-T) for all security associations associated with
this crypto template. This feature is disabled by default.
this crypto template. This feature is disabled by default.
Product
All Security Gateway products
Privilege
Security Administrator
Syntax Description
[ default | no ] natt [ include-header ] [ send-keepalive [ idle-interval idle_secs ] [ interval interval_secs
] ]
default
Disables NAT-T for all security associations associated with this crypto template.
no
Disables NAT-T for all security associations associated with this crypto template.
include-header
Includes the NAT-T header in IPSec packets.
send-keepalive [ idle-interval idle_secs ] [ interval interval_secs ]
Sends NAT-Traversal keepalive messages.
idle-interval idle_secs: Specifies the number of seconds that can elapse without sending NAT keepalive
packets before sending NAT keepalive packets is started. idle_secs is an integer from 20 to 86400. Default:
60.
packets before sending NAT keepalive packets is started. idle_secs is an integer from 20 to 86400. Default:
60.
interval interval_secs: Specifies the number of seconds between the sending of NAT keepalive packets.
interval_secs is an integer from 60 to 86400. Default: 240.
interval_secs is an integer from 60 to 86400. Default: 240.
Usage Guidelines
Use this command to configure NAT-T for security associations within this crypto template.
Examples
The following command disables NAT-T for this crypto template:
no natt
no natt
Command Line Interface Reference, Modes C - D, StarOS Release 19
1258
Crypto Template Configuration Mode Commands
natt