Cisco Cisco Packet Data Interworking Function (PDIF)
ikev1 disable-initial-contact
Disables the sending of the INITIAL-CONTACT message in the IKEv1 protocol after the node creates a new
Phase1 SA, caused either by Dead Peer Detection or by a rekey.
Phase1 SA, caused either by Dead Peer Detection or by a rekey.
Product
GGSN
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-ctx)#
Syntax Description
[ no ] ikev1 disable-initial-contact
no
Disables this command, which re-enables the sending of the INITIAL-CONTACT message.
Usage Guidelines
Use this command to disable the sending of the INITIAL-CONTACT message in the IKE v1protocol.
Examples
The following command disables the sending of the INITIAL-CONTACT message:
ikev1 disable-initial-contact
ikev1 disable-initial-contact
Command Line Interface Reference, Modes C - D, StarOS Release 19
672
Context Configuration Mode Commands I-M
ikev1 disable-initial-contact