Cisco Cisco Packet Data Gateway (PDG)

Descargar
Página de 1952
• radius-server ewag: Enables the eWAG service (IPSG service in eWAG mode), and enters the IPSG
RADIUS Server Configuration Mode, which is common for the eWAG and IPSG services.
• radius-snoop:Creates the named IPSG RADIUS Snoop service in the current context and/or enters the
IPSG RADIUS Snoop Configuration Mode.
-noconfirm
Specifies to execute the command without additional prompt or confirmation.
Usage Guidelines
Use this command to create/configure/delete an IPSG service.
A maximum of one IPSG service can be configured per context.
IPSG service commands are defined in the IPSG RADIUS Snoop Configuration Mode Commands chapter
and the IPSG RADIUS Server Configuration Mode Commands chapters.
A maximum of 256 services (regardless of type) can be configured per system.
A large number of services greatly increases the complexity of system management and may impact overall
system performance (i.e., resulting from system handoffs). Do not configure a large number of services
unless your application requires it. Contact your Cisco account representative for more information.
Caution
IP Services Gateway functionality is a license-controlled feature. A valid feature license must be installed
prior to configuring an IPSG service. Contact your Cisco account representative for more information.
Important
On entering the command with the radius-server mode or without any mode, the CLI prompt changes to:
[context_name]hostname(config-ipsg-service-radius-server)#
On entering the command with the radius-snoop mode, the CLI prompt changes to:
[context_name]hostname(config-ipsg-service-radius-snoop)#
For more information about the IP Services Gateway, refer to the IP Services Gateway Administration Guide.
Examples
The following command configures an IPSG RADIUS Snoop service named ipsg1 and enters the IPSG
RADIUS Snoop Configuration Mode:
ipsg-service ipsg1 mode radius-snoop
The following command enables the eWAG service (IPSG service in eWAG mode), and enters the IPSG
RADIUS Server Configuration Mode, which is common for the eWAG and IPSG services:
ipsg-service ipsg2 mode radius-server ewag
   Command Line Interface Reference, Modes C - D, StarOS Release 19
748
Context Configuration Mode Commands I-M
ipsg-service