Cisco Cisco Packet Data Gateway (PDG)

PCC-Data-Service Configuration Mode
Commands

This configuration mode is supported from StarOS Release 12.1 onward.

Important

The PCC-Data-Service Configuration Mode is used to configure the data flow parameters for the media data,
as well as corresponding attributes that are necessary for charging and policy enforcement decisions for the
media parameters represented by its service flows in the PCC-service. A maximum of ten service data flows
can be configured in a PCC-Data-Service instance.

Command Modes

Exec > Global Configuration > Context Configuration > PCC Service Configuration > PCC Data Service
Configuration

configure > context context_name > pcc-service service_name > data-service service_name

Entering the above command sequence results in the following prompt:

[

context_name

]

host_name

(config-pcc-data-service)#

The commands or keywords/variables that are available are dependent on platform type, product version,
and installed license(s).

Important

•