Cisco Cisco Packet Data Gateway (PDG)
vlr
Configures the Visitor Location Register (VLR) to be used by this service.
Product
MME
Privilege
Administrator
Command Modes
Exec > Global Configuration > Context Configuration > MME SGs Service Configuration
configure > context context_name > sgs-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-sgs-service)#
Syntax Description
vlr vlr_name { ipv4-address ipv4_address [ ipv4-address ipv4_address ] | ipv6-address ipv6_address [
ipv6-address ipv6_address ] } port port_number
no vlr vlr_name
ipv6-address ipv6_address ] } port port_number
no vlr vlr_name
no
Removes the configured VLR from this service.
vlr_name
Specifies the name of the VLR as an alphanumeric string of 1 through 63 characters.
ipv4-address ipv4_address [ ipv4-address ipv4_address ]
Specifies the IP address of the VLR in IPv4 dotted-decimal notation.
A secondary IPv4 address can be configured to support SCTP multi-homing.
ipv6-address ipv6_address [ ipv6-address ipv6_address ]
Specifies the IPv6 address of the VLR. ipv6_address must be entered in colon-separated-hexadecimal notation.
A secondary IPv6 address can be configured to support SCTP multi-homing.
port port_number
Specifies the SCTP port number as an integer from 1 through 65535.
Usage Guidelines
Use this command to configure the VLR used by this SGs service.
Command Line Interface Reference, Modes I - Q, StarOS Release 19
843
MME SGs Service Configuration Mode Commands
vlr