Cisco Cisco Packet Data Interworking Function (PDIF)
profile-id
Maps a QCI ID to a RAN profile ID and modifies data flow bit rate ranges.
Product
HSGW
Privilege
Administrator
Command Modes
Exec > Global Configuration > QCI - RAN ID Mapping Configuration
configure > profile-id-qci-mapping-table name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-profile-id-qci-mapping-table)#
Syntax Description
profile-id id qci num [ uplink { gbr rate [ mbr rate ] | mbr rate [ gbr rate ] } downlink { gbr rate [ mbr
rate ] | mbr rate [ gbr rate ] ]
no profile-id id
rate ] | mbr rate [ gbr rate ] ]
no profile-id id
no
Removes the specified profile ID entry from this map.
id
Specifies the profile ID to which a QCI ID will be mapped. id must be an integer value from 1 to 65535.
qci num
Specifies the QCI number to which the profile ID will be mapped. num must be an integer value from 1 to
255.
255.
uplink
Specifies that the guaranteed bit rate (GBR) and/or maximum bite rate (MBR) setting that follow this keyword
will be applied to the uplink data flow.
will be applied to the uplink data flow.
downlink
Specifies that the guaranteed bit rate (GBR) and/or maximum bite rate (MBR) settings that follow this keyword
will be applied to the downlink data flow.
will be applied to the downlink data flow.
Command Line Interface Reference, Modes I - Q, StarOS Release 19
1800
QCI - RAN ID Mapping Configuration Mode Commands
profile-id