Cisco Cisco ASR 5000
CSCF Translation Configuration Mode Commands
▀ uri-readdress
▄ Command Line Interface Reference, StarOS Release 18
3440
aor
must be an existing AoR from 1 to 79 characters in length.
filter-criteria2 criteria
Specifies the filter criteria that packets that have passed the base criteria and filter criteria1 will be compared
against. The following criteria is supported:
against. The following criteria is supported:
any
: Filters all CSCF sessions.
destination aor
aor
: Filters sessions based on the destination AoR.
aor
must be an existing AoR from 1 to 79 characters in length.
Important:
AoR regular expressions are supported. Refer to the SCM Engineering Rules Appendix in the
Session Control Manager Administration Guide for more information about regular expressions.
plmn-id mcc
mcc_code
mnc
mnc_code
: Filters sessions based on the mobile country and network
codes.
mcc_code
must be a three-digit integer from 200 to 999.
mnc_code
must be either a two or three-digit integer from 00 to 999 or
any
(any MNC code).
source address
ip_address
: Filters sessions based on source IP address.
ip_address
must be expressed in dotted decimal notation for IPv4 or colon notation for IPv6.
source aor
aor
: Filters sessions based on the source AoR.
aor
must be an existing AoR from 1 to 79 characters in length.
Usage
Use this command to readdress URIs based on specified criteria and enters the URI Readdress Configuration
Mode. Readdressing can be used for:
Mode. Readdressing can be used for:
Mobility: When roaming in a visited domain.
Service Aliases: Resolving well-known addresses via SIP-AS.
Number Translation: Adding or deleting prefixes such as +1 to/from PSTN numbers.
Voice VPNs: Using inter-office extensions to dial remote offices.
Entering this command results in the following prompt:
[context_name]hostname(config-uri-readdress)#
URI readdress commands are defined in the CSCF URI Readdress Configuration Mode Commands chapter of
this reference.
this reference.
Example
The following command readdresses sessions to a domain named
service.com
, filters sessions with a base
criteria of the source address (
1.2.3.4
) and a filter criteria of the destination AoR (
$.@test.com
):
uri-readdress type service base-criteria source address 1.2.3.4 filter-
criteria1 destination aor $.@test.com
criteria1 destination aor $.@test.com