Cisco Cisco ASR 5000
LNS Service Configuration Mode Commands
default ▀
Command Line Interface Reference, StarOS Release 18 ▄
6993
local-receive-window
Sets the window size to be used for the local side for the reliable control transport to the default of 4.
max-retransmission
Sets the maximum number of retransmissions to the default of 5.
max-session-per-tunnel
Sets the maximum number of sessions per tunnel at any point in time to the default of 65535.
max-tunnel-challenge-length
Sets the maximum length of the tunnel challenge to the default of 16 bytes.
max-tunnels
Sets the maximum number of tunnels for this service to the default of 32000.
proxy-lcp-authentication
Sets sending of proxy LCP authentication parameters to the LNS to the default state of enabled.
retransmission-timeout-first
Sets the first retransmit interval to the default of 1 second.
retransmission-timeout-max
Sets the maximum retransmit interval to the default of 8 seconds.
setup-timeout
Sets the maximum time allowed for session setup to the default of 60 seconds.
single-port-mode
Disables assignment of only port 1107 for incoming tunnels and allows dynamic assignment of ports.
subscriber
Sets the name of the default subscriber configuration to use.
tunnel-authentication
Sets tunnel authentication to the default state of enabled.
trap all
Generates all supported SNMP traps.
tunnel-switching
Sets the ability of the LNS to create subsequent tunnels to the default of enabled.