Cisco Cisco ASR 5000
ACS Ruledef Configuration Mode Commands
▀ if-protocol
▄ Command Line Interface Reference, StarOS Release 18
932
Usage
Use this command to associate different content IDs with the same ruledef, depending on the protocol being
used.
This command is only effective for charging ruledefs. See the
used.
This command is only effective for charging ruledefs. See the
how to configure charging ruledefs.
If a particular ruledef should have three different values for content-id, depending on whether the traffic is
connection-oriented WAP1.x, connection-less WAP1.x, or WAP2.0, within the ruledef we should have
configuration similar to the following:
If a particular ruledef should have three different values for content-id, depending on whether the traffic is
connection-oriented WAP1.x, connection-less WAP1.x, or WAP2.0, within the ruledef we should have
configuration similar to the following:
if-protocol wsp-connection-oriented content-id 1
if-protocol wsp-connection-less content-id 2
if-protocol http content-id 3
Presumably, the ruledef would have another configurable like “
www url contains
foo
”, which would
cause it to use different content IDs when "foo" was accessed, depending upon the protocol being used.
Example
The following command associates HTTP protocol and a content ID of
23
:
if-protocol http content-id 23