Cisco Cisco ASR 5000
Global Configuration Mode Commands (threshold ppp - url-blacklisting)
threshold total-hnbgw-hnb-sessions ▀
Command Line Interface Reference, StarOS Release 18 ▄
5977
threshold total-hnbgw-hnb-sessions
Configures alarm or alert thresholds for the total number of Home NodeB (HNB) sessions across all the HNB Gateway
(HNB-GW) services in the system.
(HNB-GW) services in the system.
Product
HNB-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold total-hnbgw-hnb-sessions high_thresh [ clear low_thresh ]
high_thresh
Default: 0 (Disabled)
Specifies the high threshold for the total number of HNB-HNB-GW sessions on IuH interfaces across all
HNB-GW services on a system that must be met or exceeded within the polling interval to generate an alert
or alarm.
Specifies the high threshold for the total number of HNB-HNB-GW sessions on IuH interfaces across all
HNB-GW services on a system that must be met or exceeded within the polling interval to generate an alert
or alarm.
high_thresh
is an integer from 0 through 1000000. A value of 0 disables the threshold.
clear
low_thresh
Default: 0 (Disabled)
Specifies the low threshold for the total number of HNB-HNB-GW sessions on IuH interfaces across all
services on a system that maintains a previously generated alarm condition. If the number of HNB-HNB-GW
sessions in a system falls beneath the low threshold within the polling interval, a clear alarm will be
generated.
Specifies the low threshold for the total number of HNB-HNB-GW sessions on IuH interfaces across all
services on a system that maintains a previously generated alarm condition. If the number of HNB-HNB-GW
sessions in a system falls beneath the low threshold within the polling interval, a clear alarm will be
generated.
low_thresh
is an integer from 0 through 1000000. A value of 0 disables the threshold.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Use this command to monitor and set alarms or alerts when the total number of HNB-HNB-GW sessions on
IuH interface across all HNB-GW services in the system is equal to or greater than the set limit.
Alerts or alarms are triggered for the total number of HNB-HNB-GW sessions on IuH interface based on the
following rules:
IuH interface across all HNB-GW services in the system is equal to or greater than the set limit.
Alerts or alarms are triggered for the total number of HNB-HNB-GW sessions on IuH interface based on the
following rules:
Enter condition: Actual total number of HNB-HNB-GW sessions on IuH interface is greater than the
high threshold.