Cisco Cisco Packet Data Gateway (PDG)
ATM Port Configuration Mode Commands
▀ threshold rx-utilization
▄ Command Line Interface Reference, StarOS Release 18
1612
Usage
Receive port utilization thresholds generate alerts or alarms based on the utilization percentage of each
configured port in relation to data received during the specified polling interval. This threshold is configured
on a per-port basis.
configured port in relation to data received during the specified polling interval. This threshold is configured
on a per-port basis.
Important:
Ports configured for half-duplex do not differentiate between data received and data transmitted.
Therefore, to avoid redundant alarms, it is recommended that only the receive or transmit utilization threshold be
configured.
configured.
Alerts or alarms are triggered for receive port utilization based on the following rules:
Enter condition: Actual percent utilization of a port for received data > High Threshold
Clear condition: Actual percent utilization of a port for received data < Low Threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
Refer to the
of the polling interval.
Refer to the
threshold poll
command in the Global Configuration Mode Commands chapter of this
reference to configure the polling interval and the
threshold monitoring
command in this chapter to
enable thresholding for this value.
Example
The following command configures a receive port high utilization threshold percent of
70
and a low
threshold of
50
for an system using the Alarm thresholding model:
threshold rx-utilization 70 clear 50