Cisco Cisco Packet Data Gateway (PDG)
Call Control Profile Configuration Mode
▀ pdp-activate restrict
▄ Command Line Interface Reference, StarOS Release 18
2054
pdp-activate restrict
Configures the system to restrict the PDP context activation based on the type of access technology.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Call Control Profile Configuration
configure > call-control-profile profile_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-call-control-profile-profile_name)#
Syntax
[ no | remove ] { { access-type { gprs | umts } { all | location-area-list instance
instance } } | { pdp-type { all | dual-ipv4v6 | ipv4 | ipv6 | ppp } { access-type { gprs
| umts } { all | location-area-list instance instance } } } | { secondary-activation
access-type { gprs | umts } { all | location-area-list instance instance } } }
instance } } | { pdp-type { all | dual-ipv4v6 | ipv4 | ipv6 | ppp } { access-type { gprs
| umts } { all | location-area-list instance instance } } } | { secondary-activation
access-type { gprs | umts } { all | location-area-list instance instance } } }
no | remove
Either of these prefixes removes the previously configured restriction on PDP context activation and returns
the ‘allow’ default.
the ‘allow’ default.
access-type { grps | umts }
Specifies the access technology type for which to restrict PDP context activation.
gprs
: Enables access type as GPRS.
umts
: Enables access type as UMTS.
all
: Configures the system to restrict all PDP context activation requests from the MS.
location-area-list instance instance
: Specifies the location area instance to restrict PDP
context activation, where
list_id
must be an integer from 1 through 5. The value must be an
already defined instance of a location area code (LAC) list created with the
location-area-list
command.
pdp-type
Sets the configuration to restrict PDP activation based on the requested PDP type.
To restrict more than one type of PDP, the command must be reissued for each PDP type.
To restrict more than one type of PDP, the command must be reissued for each PDP type.
all
: restricts activation of all types PDP.
dual-ipv4v6
: restricts activation when dual-IPv4v6 PDP contexts are requested.
ipv4
: restricts activation when IPv4 PDP contexts are requested.
ipv6
: restricts activation when IPv6 PDP contexts are requested.
ppp
: restricts activation when PPP PDP contexts are requested.