Cisco Cisco Packet Data Gateway (PDG)
Global Configuration Mode Commands (T-threshold phspc)
▀ threshold phsgw-max-eapol-retry
▄ Command Line Interface Reference, StarOS Release 18
5752
threshold phsgw-max-eapol-retry
Configures alarm or alert thresholds for the maximum number of Extensible Authentication Protocol over LAN
(EAPOL) retries in PHSGW.
(EAPOL) retries in PHSGW.
Product
PHSGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold phsgww-max-eapol-retry high_thresh [ clear low_thresh ]
high_thresh
Default: 0
Specifies the high threshold number of EAPOL retries for any one PHSGW service. This number must be
met or exceeded within the polling interval to generate an alert or alarm.
Specifies the high threshold number of EAPOL retries for any one PHSGW service. This number must be
met or exceeded within the polling interval to generate an alert or alarm.
high_thresh
is an integer from 0 through 1000000. A value of 0 disables the threshold.
clear
low_thresh
Default: 0
Specifies the low threshold number of EAPOL retries for any one PHSGW service. This number must be met
or exceeded to maintain a previously generated alarm condition. If the number of subscribers falls beneath the
low threshold within the polling interval, a clear alarm will be generated.
Specifies the low threshold number of EAPOL retries for any one PHSGW service. This number must be met
or exceeded to maintain a previously generated alarm condition. If the number of subscribers falls beneath the
low threshold within the polling interval, a clear alarm will be generated.
low_thresh
is an integer from 0 through 1000000. A value of 0 disables the threshold.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Set the monitoring and clearing thresholds for PHSGW EAPOL retries.
Alerts or alarms are triggered for handoff denials based on the following rules:
Alerts or alarms are triggered for handoff denials based on the following rules:
Enter condition: Actual number of PHSGW EAPOL retries in any one PHSGW service is greater than
or equal to the high threshold.
Clear condition: Actual number of PHSGW EAPOL retries in any one PHSGW service is less than the
low threshold.
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
of the polling interval.