Cisco Cisco Packet Data Gateway (PDG)
HNB-PS Network Configuration Mode Commands
▀ map core-network-id
▄ Command Line Interface Reference, StarOS Release 18
6508
map core-network-id
Maps/associates the PS core network identifier to a default SGSN in the network using an SGSN point code to allow
HNBs to access the UMTS network.
HNBs to access the UMTS network.
Product
HNB-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > HNB-PS Network Configuration
configure > ps-network ps_instance
Entering the above command sequence results in the following prompt:
[local]host_name(config-ps-network-instance_id)#
Syntax
map core-network-id cn_id point-code sgsn_point_code
no map core-network-id cn_id
no
Removes the mapping of a PS core network id with particular SGSN point code.
cn_id
Specifies the core network identifier configured to represent a UMTS PS core network as n integer from 0
through 4095.
Multiple instance of this command can be mapped with different SGSN point codes.
through 4095.
Multiple instance of this command can be mapped with different SGSN point codes.
point-code
sgsn_point_code
Specifies the SS7 address of the default SGSN in the PS network.
point_code
is an SS7 point code in dotted-decimal ###.###.### or 8-digit decimal ######## format.
Only one instance of this SGSN point code can be mapped with one PS core network identifier.
Usage
Use this command to map a UMTS PS core network identifier with a particular SGSN point code.
This command can be entered multiple times with same SGSN point code to map with one or more PS core
network Id, but a particular core network identifier can be mapped to one SGSN only.
This command is instrumental in Iu-Flex functionality, whenever HNB-GW receives RESET/RESET-RES
messages from SGSN with Global CN-ID information element, the response from HNB-GW is sent to the
node configured for that particular Global CN-ID.
If the RESET/RESET-RES messages do not have Global CN-ID IE, then the response of those messages is
directed to the default SGSN which is configured using
This command can be entered multiple times with same SGSN point code to map with one or more PS core
network Id, but a particular core network identifier can be mapped to one SGSN only.
This command is instrumental in Iu-Flex functionality, whenever HNB-GW receives RESET/RESET-RES
messages from SGSN with Global CN-ID information element, the response from HNB-GW is sent to the
node configured for that particular Global CN-ID.
If the RESET/RESET-RES messages do not have Global CN-ID IE, then the response of those messages is
directed to the default SGSN which is configured using
sgsn point-code
command in this mode.
Example
The following command configures the PS core network identifier
101
with an SGSN point code
1.2.3
: