Cisco Cisco Packet Data Gateway (PDG)
Command Line Interface Reference, StarOS Release 18 ▄
7509
Chapter 238
Operator Policy Configuration Mode
Operator Policy configuration mode associates APNs, APN profiles, IMEI ranges, IMEI profiles, an APN remap table
and a call control profile to an operator policy. These profiles and tables are created and defined within their own
configuration modes to generate sets of rules and instructions that can be reused and assigned to multiple policies.
and a call control profile to an operator policy. These profiles and tables are created and defined within their own
configuration modes to generate sets of rules and instructions that can be reused and assigned to multiple policies.
The Operator Policy Configuration Mode is used to create and manage operator policies for MME, S-GW, SAEGW,
and SGSN configurations.
and SGSN configurations.
A maximum of 1,000 operator policies can be defined, including the “default” operator policy.
A maximum of 128 APN profiles can be associated with a single operator policy.
A maximum of 128 IMEI profiles can be associated with a single operator policy (SGSN-only).
Only one APN remap table can be associated with a single operator policy.
Only one call control profile can be associated with a single operator policy.
Using the Operator Policy feature allows the operator to fine-tune any desired restrictions or limitations needed to
control call handling per subscriber or for a group of callers across IMSI ranges.
control call handling per subscriber or for a group of callers across IMSI ranges.
Mode
Exec > Global Configuration > Operator Policy Configuration
configure > operator-policy policy_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-opr-policy-policy_name)#
Important:
The commands or keywords/variables that are available are dependent on platform type, product
version, and installed license(s).