Cisco Cisco Packet Data Interworking Function (PDIF)
APN Configuration Mode Commands
ignore-alt-config ▀
Command Line Interface Reference, StarOS Release 18 ▄
1363
ignore-alt-config
Configures preference to APN/AAA-defined behavior/parameters. If the parameters are not defined in APN/AAA, they
will not be provisioned from any other source/configuration in the system, even if they are available there.
will not be provisioned from any other source/configuration in the system, even if they are available there.
Product
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > APN Configuration
configure > context context_name > apn apn_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-apn)#
Syntax
[ no ] ignore-alt-config { no-dns | no-s6b }
no
Disables DNS server address preference or S6b authentication on a per-APN level.
no-dns
Gives preference to DNS server address configured in APN. If name server addresses is not found in APN
configuration, it will not be provisioned from SGi context, even if it is configured there.
configuration, it will not be provisioned from SGi context, even if it is configured there.
no-s6b
Enables/disables S6b authentication on a per-APN level.
Ignores alternate service-level configuration for S6b authorization when S6b authorization is disabled at
APN.
Ignores alternate service-level configuration for S6b authorization when S6b authorization is disabled at
APN.
Usage
Use this command to enable/disable DNS server address preference or S6b authentication on a per-APN
level.
level.
Important:
Configuration in APN will take precedence over configuration in P-GW service configuration.
Example
The following command to give preference to DNS server address configured in APN:
ignore-alt-config no-dns