Cisco Cisco Packet Data Interworking Function (PDIF)
APN Configuration Mode Commands
▀ ip local-address
▄ Command Line Interface Reference, StarOS Release 18
1378
ip local-address
Configures the local-side IP address of the subscriber's point-to-point connection.
Product
GGSN
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > APN Configuration
configure > context context_name > apn apn_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-apn)#
Syntax
ip local-address ip_address
no ip local-address
no
Removes a previously configured IP local-address.
ip_address
Specifies an IP address configured in a destination context on the system through which a packet data
network can be accessed.
network can be accessed.
ip_address
must be expressed in IPv4 dotted-decimal notation.
Usage
This parameter specifies the IP address on the system that the MS uses as the remote-end of the PPP
connection. If no local address is configured, the system uses an unnumbered scheme for local-side addresses.
connection. If no local address is configured, the system uses an unnumbered scheme for local-side addresses.
Example
The following command configures a local address of 192.168.1.23 for the MS:
ip local-address 192.168.1.23