Cisco Cisco Packet Data Interworking Function (PDIF)
Call Control Profile Configuration Mode
▀ sgsn-address
▄ Command Line Interface Reference, StarOS Release 18
2100
sgsn-address
Defines the IP addresses for peer SGSNs in a static SGSN address table. These configured addresses can be used if
operators wish to bypass DNS.
operators wish to bypass DNS.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Call Control Profile Configuration
configure > call-control-profile profile_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-call-control-profile-profile_name)#
Syntax
sgsn-address { nri nri | rac rac-id lac lac_id | rnc_id rnc_id } [ nri nri ] prefer {
fallback-for-dns | local } address { ipv4 ip_address | ipv6 ip_address } interface { gn |
s16 }
fallback-for-dns | local } address { ipv4 ip_address | ipv6 ip_address } interface { gn |
s16 }
no sgsn-address { ipv4 ip_address | ipv6 ip_address } { nri nri | rac rac_id lac lac_id
[ nri nri | rnc_id rnc_id } [ interface { gn | s16 } ]
[ nri nri | rnc_id rnc_id } [ interface { gn | s16 } ]
no
Disables the specified peer-SGSN address configuration.
rac rac_id
Identifies the foreign routing area code (RAC) of the peer-SGSN address to be configured in the static peer-
SGSN address table.
SGSN address table.
rac_id
must be an integer from 1 to 255.
lac lac_id
Identifies the foreign location area code (LAC) ID of the peer-SGSN address to be configured in the static
peer-SGSN address table.
peer-SGSN address table.
lac_id
must be an integer from 1 to 65535.
rnc_id
rnc_id
Optional. Specifies the target RNC ID that maps to the address of the peer SGSN via the S16 interface. The
RNC ID is used by the S4-SGSN for inter-SGSN SRNS relocations. Valid entries are 1 to 65535. This setting
only applies if SRNS relocation has been configured via the
RNC ID is used by the S4-SGSN for inter-SGSN SRNS relocations. Valid entries are 1 to 65535. This setting
only applies if SRNS relocation has been configured via the
srns-inter
and/or
srns-intra
commands in
Call Control Profile Configuration Mode.
nri nri
Identifies the network resource identifier stored in the P-TMSI (bit 17 to bit 23).
nri
must be an integer from
0 to 63.