Cisco Cisco Packet Data Interworking Function (PDIF)
Card Configuration Mode Commands
▀ link-aggregation
▄ Command Line Interface Reference, StarOS Release 18
2172
link-aggregation
Configures system priority and toggle link settings for Link Aggregation. These parameters are usually changed to
match the feature requirements of the remote Ethernet switch.
match the feature requirements of the remote Ethernet switch.
Product
WiMAX
PDSN
HA
FA
GGSN
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Card Configuration
configure > card card_number
Entering the above command sequence results in the following prompt:
[local]host_name(config-card- slot_number)#
Syntax
link-aggregation { system-priority priority | toggle-link } [-noconfirm ]
{ default | no } link-aggregation { system-priority | toggle-link } [-noconfirm ]
default
Resets the configuration to the default.
link-aggregation system-priority priority
This command sets the system priority used by Link Aggregation Control Protocol (LACP) to form the
system ID.
system ID.
priority
is a hexadecimal value from 0x0000 through 0xFFFF. Default is 0x8000 (32768).
toggle-link
Sets the system to toggle link on port switch.
-noconfirm
Executes the command without additional prompting for command confirmation.