Cisco Cisco Packet Data Interworking Function (PDIF)
Channelized Port Configuration Mode Commands
toh-sdsf ▀
Command Line Interface Reference, StarOS Release 18 ▄
2223
toh-sdsf
Enable/disable line SDSF BER thresholds and configure the line transport overhead (TOH) signal degrade and signal
failure (SDSF) bit error rate (BER) threshold.
failure (SDSF) bit error rate (BER) threshold.
Product
SGSN
Privilege
Security Administrator, Administrator
Syntax
toh-sdsf toh_value
default toh-sdsf
default
Resets the default which disables this threshold.
toh_value
To facilitate configuration the SD and SF rates have been combined into a single setting. .
0: Disabled
1 -1.E-04
2 - 1.E-05
3 - 1.E-06
4 - 1.E-07
5 - 1.E-08
6 - 1.E-09
7 - 1.E-10
8 - 1.E-11
Usage
This command can be used to configure the line threshold whether the port is active or standby and sets a
standard option for the paired values of the line’s signal degrade and signal failure (SDSF) BER.
The SD is kept at a value of 100 erroredBits/sec less than the corresponding value of the SF. So if the SD
threshold is configured at 1 error in every 100000 bits/sec, then the SF threshold automatically becomes 1
error in every 1000 bits/sec.
The port will go operationally down as soon as the SD threshold is crossed.
standard option for the paired values of the line’s signal degrade and signal failure (SDSF) BER.
The SD is kept at a value of 100 erroredBits/sec less than the corresponding value of the SF. So if the SD
threshold is configured at 1 error in every 100000 bits/sec, then the SF threshold automatically becomes 1
error in every 1000 bits/sec.
The port will go operationally down as soon as the SD threshold is crossed.
Example
toh-sdsf 1