Cisco Cisco Packet Data Interworking Function (PDIF)
Context Configuration Mode Commands E-H
hnbgw-service ▀
Command Line Interface Reference, StarOS Release 18 ▄
2519
hnbgw-service
Creates or removes an Home Node B Gateway (HNB-GW) service or configures an existing HNB-GW service and
enters the HNB-GW Service Configuration Mode for Femto UMTS access networks configuration in the current
context.
enters the HNB-GW Service Configuration Mode for Femto UMTS access networks configuration in the current
context.
Product
HNB-GW
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx)#
Syntax
hnbgw-service hnbgw_svc_name [ -noconfirm ]
no hnbgw-service hnbgw_svc_name
no
Removes the specified HNB-GW service from the context.
hnbgw_svc_name
Specifies the name of the HNB-GW service. If
service_name
does not refer to an existing service, the new
service is created if resources allow.
hnbgw_svc_name
is an alphanumeric string of 1 through 63 characters.
Important:
Service names must be unique across all contexts within a chassis.
-noconfirm
Executes the command without any additional prompt and confirmation from the user.
Usage
Use this command to enter the HNB-GW Service Configuration Mode for an existing service or for a newly
defined service. This command is also used to remove an existing service.
A maximum of one HNB-GW service which is further limited to a maximum of 256 services (regardless of
type) can be configured per system.
defined service. This command is also used to remove an existing service.
A maximum of one HNB-GW service which is further limited to a maximum of 256 services (regardless of
type) can be configured per system.
Caution:
Large numbers of services greatly increase the complexity of management and may impact overall
system performance (for example, resulting from such things as system handoffs). Therefore, it is recommended that a
large number of services only be configured if your application absolutely requires it. Please contact your local service
representative for more information.
large number of services only be configured if your application absolutely requires it. Please contact your local service
representative for more information.